EZGO Driven Clutch Puller

Discussion in 'EZGO Gas 4 Stroke' started by Ericl, Jan 4, 2019.

  1. Ericl

    Ericl New Member

    I have a 2011 EZGO ST with a Kawasaki engine. I am having a hell of a time getting the driven clutch off. I found these two pullers from the internet, both made by Red Hawk any experience with either product?
    Thank you
    B1961928-712E-48A4-B6E4-4CBE66B4DF38.jpeg
    D64674D3-3940-43D4-B701-E915C18E8D35.png
     
  2. HotRodCarts

    HotRodCarts Cartaholic

    I'm pretty sure EZGO went to a tapered shaft in 2008 on the driven clutch with they switched to the Kawasaki engine. I've never pulled a driven clutch on a EZGO golf cart with the Kawasaki engine but I believe the drive clutch and the driven clutch both use the same puller on the 2008 and newer carts. It should be like the bolt/puller you posted the picture of. @Nubs may know the dimensions to make one. Wait for him to see your post and chime in.
     
  3. Nubs

    Nubs Cartaholic

    I do believe Rod is right but I have not removed one Myself, look to see if it’s threaded in the end.
     
  4. Ericl

    Ericl New Member

    Thanks for the quick responses, the shaft out of the transmission is threaded.
     

Share This Page